Staub-electronics SM-PROJ-XL-BLK STRONG - UNIVERSAL FINE ADJUST PROJ Uživatelský manuál stáhnout pdf (Strana 8)

Pg. 8

SM-PROJ-XL Installation Manual

After the projector has been attached to the mounting

base, it can be attached to the projector mount body.

Step 6. Hanging the Projector

1. Lift the projector and position the front lip of the

mounting base (C) at the bottom-rear of the mount

body(B),andslideitintotheopening.(Figure10)

The mounting base should slide into the body with

ease with the rails engaged on both sides.

Note: Ifthemountingbasewillnotslidecompletely

onto the mount body, the mounting base

or the mount body has been installed

backwards, or the screws (E) are in place

and must be removed.

Figure 10

Figure 11

Figure 12

Projection Screen

(B)

(C)

Projection

Screen

(E)

2. Next, insert the screws (E) back into the holes on

the base as shown, and leave them loose enough

to allow the mounting base to slide forward and

backward.(Figure11)

Note: Lift the projector some when threading in the

screwstoavoidcross-threading.

3. Now let the projector hang from the mount.  If the

projector leans forward or backward, slide the base in

themountbodytocorrecttheimbalance.(Figure12)

4. Afterthenaturalpositionforthebestbalanceisfound,

tightenall4screws(E)securelyusingthe3mmAllen

wrench (T2).

Projection Screen

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Staub-electronics SM-PROJ-XL-BLK STRONG - UNIVERSAL FINE ADJUST PROJ Uživatelský manuál Strana 8